Recent content by alfsauve

Either LR or Garmin is a wise choice. Expensive but well worth it. Especially, double especially, if you shoot at an indoor range or a public, multishooter outdoor one.

When I had some 625 revolvers discovered I could put my index finger through the center hole of the clip and press the round in place with my thumb, using the other hand to “feed” the rounds. This proved easier and quicker then even using a BMT Mooner. De-mooning could be done with a knife...

Thank you, Ed. Decided to go ahead. .16mm with 10% infill. Inland PLA+ It's blue cause that's my least used color and I had plenty on hand. Only have 7 empty brass on hand and one was SPP. What are the odds? Then I thunk. Why not make a spindle to hold my empty moon clips? Heck if...

I bought a single stage C press first because it was cheap and what I could afford. However there‘s really no advantage from a learning stand point especially with the LNL. Put in one die and treat it like a single stage. When you finish that process swap out dies, easy to do with LNL, and do...

With the Hornady you can easily put in only one die at a time and load just like a single stage press. Or put in all dies, but continue to only load one round at a time. Or just put in the sizer and expander, prime and powder off press, swap out the dies and seat on press. Or go full...

10 minimum. But depending on the gun this can get expensive, very expensive. Glock 17 rounders are available at $10ea at GSSF matches. If you’re a competitor it means less reloading during the match. The ultimate goal would not have to load mags during a match. And no I’m not quite there...

For many of the models there are rack assist rear plates. Adds to the profile but can be a big help.

I'm with 2ndtimer. They all have very long shelf life so no worries. Buy all you can afford and then some.

The some of the older manuals said a magnum primer was required. I've followed that advice and never regretted it. My favorite fireball is the one from my TC .357Max using a full power load of H110. What's unique about the picture is that the fireball is in the full sunlight and still quite...

Looks like a seating die, but I can't see what's on the inside looking from the bottom up

And you're not getting all three because?

I decided on the Ruger PC9 because of the plethora of aftermarket parts and that it takes Glock mags. First time out I classified B class in steel challenge iron sights with it. Keeper.

I bought a Mosin Nagant for $90 not too many years ago. It was so cheap I cut it down to 18" barrel and sporterrize the stock. Even then someone bought it for $300 recently. The gun store owner told me he'd just sold a whole case to one customer who was going to put a plexiglass top on it...

Could this become, if the BATF was so inclined, a jurisdictional issue? Unless the laws apply to all business equally then the state has no authority to dictate how Federal licenses conduct their business.

Perhaps I should have said, "slug your barrel." I guess I threw out the word bore as a generic word, sorry about that. However, I'd guess many (most?) of us will never slug the barrel be it the bore or the throat or... We can, which is what I did, experiment with different diameters and see...