Recent content by deadeye dick

Taurus PT 1911 about 20+ years old. Can the right side safety be removed? Just want to clean up the r/s.

How do you know once fired IS once fired? Most of my brass looks like new after many firings. And talk about fired brass, .45 colt is still rare new or used.

Wiki didn't say. Was a O/U 30cal top 12 GA bottom. Ran from 59 to 61

Remember Shotgun Slade with Scott Brady without the gut.

Sounds Easy LOL

Just bought 3 boxes at Cabels. Always shot lead because i never saw any plated here. Shot a cyl. full yesterday in my Blackhawk 357. Couldn't see any difference.

In my neck o the woods the powder and primer prices are going up considerably. The local S/W and Academy prices are $10.00+ higher .($45.00 to $50.00 a LB. and primers $2 to $3.00 more per 100 Is this just here or all over.

7.0 Bullseye for me under a 200 GR. Berrys plated RN. or 7.6 GR Greendot. 6.4 of HP38 for 230 GR lead cowboy load. These are L/C loads To fit the ACP cyl all you need is a fine mill bastard file. The cyl. comes with a over size base pin cylinder bushing that needs to be fitted to each...

I have the Cattleman II in .45 lC. Got the 045 ACP cyl. from Taylors. The only thing i had to do was to fit the base pin hole to the frame. Locked up perfectly. As far as powder, i use Greendot for .45 LC

The dippers are great if you want to throw the load for trhat dipper but what about a load between the dippers.

This may sound dumb as i have been reloading for 20 years but please explain what a M die is

Don't know if age is a factor but here's my input and experience. I am 86 yrs. old and rode motorcycles for 66 years. At 85 i started making stupid mistake's on the road. I lost my edge. The icing on the cake was when i hit something in the road at 60 MPH Did not go down but did break two...

Thanks for the heads up. Didn't read the whole bill.

Me too. I also have the Ronin. Love it.

In SC you are obligated to inform the LEO that you are carring.