I had the privilege of receiving a pair of the "TheGerman"s 3D Printed Loading Blocks. These were made for the .223/5.56 caliber. They are setup for 55 shells/Loads. This allows for separation of loads all on the same block. The fit was very good, absolutely a great Idea. I especially like the smaller size. These loading blocks are nowhere near the size of the MTM or RCBS loading blocks.
If I had to say something I didn't care for, it would be the size of the Cartridge Fit, that was printed on the outside edge that showed .223/5.56, it was difficult to read, probably due to lack of space. My Suggestion would be to leave it off, the block is Great, cases set in the holes very nicely,
I will have more calibers as soon as "TheGerman" comes up with their development.
Contact Tom at "[email protected]", tell him dgod sent you, yu won't be disappointed.
Great Product
Dan
If I had to say something I didn't care for, it would be the size of the Cartridge Fit, that was printed on the outside edge that showed .223/5.56, it was difficult to read, probably due to lack of space. My Suggestion would be to leave it off, the block is Great, cases set in the holes very nicely,
I will have more calibers as soon as "TheGerman" comes up with their development.
Contact Tom at "[email protected]", tell him dgod sent you, yu won't be disappointed.
Great Product
Dan