Recent content by 1Pocket

I think I read somewhere that the new Delegate Morefield is going to introduce a new bill for the Castle Doctrine in VA. Anyone know about this.

Does anyone know/know where I can find the value of a 1990 Case Dale Earnhardt commemorative knife in wooden presentation case.

Went in the Claypool Hill Va Walmart this past week end and they had 8 or 9 50 rd boxes of .40, 3 boxes of .44mag and 1 box of .357 mag Winchester Personal Defense ammo. First I have seen there in several weeks. I bought the .357 ammo.

Count me in. I have a no dash 686 6"

Anyone use these hearing protectors. Do they work well or is it just advertising hype.

4" Nickel Python "64 vintage

2nd Gen G19 and a G30

Never had an ATM card and never will. Always carry some "emergency cash" for just such occurrences.

Pics Due to ISP problems I have had a problem posting pictures. Hope this works. JohnBT: Per the link you sent the grips appear to correct for the period. The underlug is hollow, is there a significance to that.

JohnBT: Thanks for the link on the grips. I wasn't aware of all the differences in the grips. I am looking at the link from work but will take a closer look at home and try to post a picture. Bob

Oro, I am not much of a photographer but I will try this evening after work.

I just purchased a 4" Nickel Python that the owner said was unfired. Serial # 390XX indicates mfg in 1964 if I understand the charts correctly. I can see no evidence of it having been fired but then I am not an expert.. Was in a plastic Colt box which I assume was not original in '64. Was 1K...

what would be some good "low power" .357 ammo for use in a 3" Ruger SP101

You might look into a product called micro-mesh. It is used to remove scratches from acrylic aircraft windows and return them to optical clarity. It is a series of abrasives embedded in a rubber like base. Grit sizes go down to about 12000. I have used it to polish the shafts of cue sticks...

Buchanan Co here