Recent content by 2011redrider

I have been using those pans for a couple of years. They work great just can't do a big batch or its hard to get the brass to fall thru the slots.

some lanolin and iso alcohol. I use the red heat since I cant find the 91 or 99% alcohol where we are. 1oz of lanolin and a bottle of heat. works great , just have t let it dry a bit for the alcohol to evaporate. Amazon or pipingrock.com for the lanolin.

Cant sell them without a FFL and ITAR registration. http://castboolits.gunloads.com/showthread.php?69429-Selling-cast-bullets

The lanolin seems to leave a film on the rubber liner of my Frankford Tumbler. I run cases w lube thru my old dry tumbler and it removes the lube in about 10-15 minutes. If you get the slime in the wet tumbler from lanolin the only thing that cleans it seems to be some woolite and water. I...

I've only seen S & B cases in 9mm. They are so tight that I sort them out into the scrap bucket! They are not worth the trouble and I have 3, 50 cal ammo cans of 9mm brass and not may S & B cases in the mix.

Might also look at the HF bench https://www.harborfreight.com/60-in-4-drawer-hardwood-workbench-63395.html See it on sale plus use a 20% coupon. May be an option to get started with. Looks like its 95 bucks w coupon till the 30th?

I have several buckets of 40 SW brass from a local PD range. The majority of it is Federal Hyrda shock round fired in a SW MP Hybrid Gen 1 with a gen 2 triggers. They all seem to have a slight bulge. Since you indicate you are using a MP you will may continue to get buldges, not as severe as...

Most of my dies have already beed moved to our new home in North Idaho. Only calibers I still have to pack in both dies sets(cowboy and regular carbide sets) are in 45 Colt. Both sets have stepped style expander plugs and both threads are the same and will work in either set. I assume they...

If you use a Universal Decap Die it will not damage your die, and allow the primer pocket to get some cleaning. I decap all my brass with a decap only die and them wet tumble in a Frankford tumbler. Cases come out like new inside and out. Dry tumbling doesn't seem to clean the inside of the...

Noe makes the bushings, but, you need the die kit to hold the bushings. Die is about 40 and bushings run about 9. https://noebulletmolds.com/site/product-category/sizing-tools/bushings/348cal-bushings

It will work on the Co-ax but it will need the shell holder adapter instead of the jaws. Found this video with the Co-ax.

We just bought a new house in North Idaho that has a storage room in the basement, all concrete or block..10x30 that she said I can have or the large shop has a 40' long bench and is plumbed for air. Haven't decided yet but shop has gas heater, full insulation and bench already there. Lots of...

I had that happen when I first got my Frankford tumbler, but, only in 223. The pins were .041 and I switched to .047 and no problems since as 2 pins wont fit in the pocket and one will slide thru. Tried the chips but wasn't happy with them and went back to pins. chips were coated in cutting...

I have some 40 brass from a local PD range that was fired in a modified SW MP40's that have similar bulges as the glocks. As far as I know the modifications were a gen 2 trigger but guns were gen 1 as they were not allowed to purchase the gen 2 unless it had been on the market for at least 5...

PM sent