-
-
Varminterror replied to the thread Considering a new action.Accuracy is in the barrel. Drivability is in the action. It’s not hard to drive nicer than an R700, but many folks will never demand so... -
Varminterror replied to the thread Little help with .308 sizing..It's been WELL before covid since I have done so, and I'm sure other groups offered the same, but Lee, RCBS, Hornady, and Forster all...
-
Varminterror replied to the thread What reloading components have you overbought?.Real talk ^ And with only a FEW exceptions, components have appreciated fast enough over 4-5yr holds to be able to draw greater than...
-
Varminterror replied to the thread What reloading components have you overbought?.For the first half of my reloading life, I bought the sold line that I needed to try a lot of different powders with a lot of different...
-
But by the time you size most of the neck, you've contacted the body. We'll never all agree about neck sizing with a FL die, at least...
-
Exactly. There was a fad for a while where folks were neck sizing, and using a body die whenever chambering got tough. I never...
-
Every neck sizer is a closet full length sizer because they all will eventually have to FL size the case in order to keep using it. A...
-
Varminterror replied to the thread Little help with .308 sizing..For the life of me, I don’t understand why they aren’t selling the “-“ shell holder sets any more, and only selling now the “+” sets.
-
Varminterror replied to the thread Little help with .308 sizing..You’re missing a lot in the application of these practices here. Yes, if you use a grossly undersized standard die, not a bushing die...
-
Varminterror replied to the thread Little help with .308 sizing..You CAN turn your own mandrels if you choose to do so and have the ability, but it’s easier to just buy them. I tend to keep a few...
-
Varminterror replied to the thread Little help with .308 sizing..This process is kinda upside down. You will FL size before expanding. From fired brass: Decap Wash Anneal Lube FL Size (2-3 thou...
-
Varminterror replied to the thread Little help with .308 sizing..Don’t neck turn. More often than not you will be causing damage to your brass which ends up revealing itself as increased velocity...
-
The die is for the Lyman 310 hand tool, useable with the Lyman Tru-Line presses as well. The adapter ring is threaded 7/8 - 14, to...
-
That even goes down to specific lots of the exact same headstamp, for some brands vary quite a bit, in their own production. Then...
-
Varminterror replied to the thread Garmin Xero C1 Pro Chronograph.Has anyone ran their battery all the way dead, to the point the unit shut down while in use? I have ran down a couple battery cycles on...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
