-
-
mdi replied to the thread Blown primers on win brass.Inspect/measure pockets to make sure they aren't too big ID... -
mdi replied to the thread Lee's Factory Crimp Die?.Mos Most discussed, least important...
-
Next to brass cleaning the LFCD is the most discussed topic on the internet! It is one of the greatest reloading tools known to man! I...
-
mdi replied to the thread Lee's Factory Crimp Die?.FWIW; I have been reloading for nearly 40 years and have never needed to post crimp resize any handgun handload from 32 Auto up to 45...
-
Looks like a seating die, but I can't see what's on the inside looking from the bottom up
-
The Noe 240 wfn feeds from my Rossi 92 perfect. I have not needed to trim brass .It’s a really nice bullet . It shoots well for me . I’m...
-
Just occurred to me...what about the boxes??? Oh the humanity!
-
mdi replied to the thread Case cleaning/polishing.I use Turtle Wax, auto wax. Some polishes may have a fine abrasive which I don't want on my brass...
-
And just about any liquid car wax will do
-
I doubt it. Powder was dispense with the Frankford Arsenal intellidropper properly set up and calibrated and all case where inspected...
-
What you are going to learn is this: At some point, as you reduce your loads, THE NECK WILL STOP SEALING. When that happens it will...
-
mdi reacted to Shivahasagun's post in the thread New .40 S&W loader. (I think I'm prepared) with
Like.
Plunk test / OAL of cartridges. -
I full length resize, unless I'm loading for a tight neck chamber. Then I use bushing dies. I've seen very little to no improvement in...
-
mdi replied to the thread .38 Special-Reloads, or not? Western wadcutters..Without a second thought, I would pull the bullets, toss the powder and reuse the primed brass. Pulling with an impact puller may be...
-
mdi reacted to Ohen Cepel's post in the thread .38 Special-Reloads, or not? Western wadcutters. with Like.
I am guessing a reload. Marks on the brass part of it, but I'm not sure factories loaded much WC ammo which wasn't near flush with the...
-
-
Loading…
-
Loading…
-
Loading…