Recent content by alexmc

  1. A

    Low Load with big over pressure signs???

    I'm sorry about the confusion. For some reason the photo of the primers I took was flipped upside down when formatted. The way it was posted, the left was the 23.4 and the right 23.0. The higher load was definitely flatter, but it's good to hear all the word about the primers not being seriously...
  2. A

    Low Load with big over pressure signs???

    The left three are from the 23.0 gr load. The right three were 23.4gr. The flattening isn't severe, but easily noticeable.
  3. A

    Low Load with big over pressure signs???

    Thanks for all the replies guys. I was hoping this was bad brass but that still leaves the issue of the flattened primers. I know Winchester SR primers aren't the hardest but I don't think I should be getting flattening at only 23.4 gr. I individually measure each charge and I'm 99.999% positive...
  4. A

    Low Load with big over pressure signs???

    So I went to the range today with a new set of development loads I was very hopeful for. I ended up getting to shoot ten of them, then driving home to the bullet puller. My rifle is self-built with a 20" 1:8" twist AR Stoner HBAR barrel with Wylde chamber and a syrac ordinance adj. gas block...
Back
Top