For your Op Rod question try posting directly on Dillon's forum. They are good about answering posts but you are going to have to give them a little more detail than you supplied here. https://www.dillonprecision.com/forum.html
Also if you look on the Dillon site there are instruction on how to...
I have done this for my 9mm rounds. Start low and work up! I typically use RMR thick plated which can be loaded using FMJ data up to 1500fps but I still start in the lead range and work up until I find a load that cycles my gun well and is accurate.
The thread your looking for is on Brian's forum, http://www.brianenos.com/forums/index.php?showtopic=181925. I made one myself and it does help. I also had some side to side slop that caused the primer bar to chatter a bit as it slides out but instead of a bearing I used a small spring clamp to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.