Recent content by Bruce H.

The load that you have listed is what I use in my P95. Your P95 will operate consistently with much less powder than what is required for a Sig, Glock or S&W 9mm. When I shoot my P95 with that load there is very little recoil. It is a great load for plinking. If you do have any feeding...

You might want to try a pair of the Hogue full length rubber grips. Not the Boot Grip, but the full size grip that allows you to grip the gun with all of your fingers. The rubber grip will allow your wife to fire the gun without hurting her hand and it will also protect your middle finger...

Here is a website that shows how to take the SAA style gun apart: http://warlockfirearms.blogspot.com/2010/06/colt-single-action-revolver-disassembly.html I have a Cimarron Model P and put one of the Heine trigger/bolt springs into it and am very pleased with the trigger/bolt performance. I...

Is the gun new or used? If it is used, the previous owner probably had the sideplate off and did not reassemble the gun properly. I believe that the forwardmost screw in the sideplate, the one in front of the trigger on the right side of the gun, is what holds the crane in place. Check to...

Make sure that you can pull the trigger in double-action on a revolver, before you buy it. Double-action is where you don't cock the hammer first. I say this, because my wife can't shoot a revolver in double-action. She is just not strong enough. She also has trouble pulling the slide back...

I put one of the Wolff reduced power springs in my Cimarron Model P about a year ago and have not had one light strike. I didn't have any before I replaced the spring either. I don't think you can go wrong by repacing the factory spring with one of the Wolff's.

post deleted by author.

Brian, have you recently removed the beam to clean the scale? I believe that the beam is magnetically dampened. The copper colored metal part that sticks out of the back of the beam near the pointer end is part of the magnetic dampening system. I remember one time I took the beam off of mine...

I have searched the forum for an answer and have not found it. I have a .357 Magnum caliber 4 5/8" Cimarron colt clone. I have always shot jacketed or plated bullets in it because I don't want to deal with leading. A couple of months ago I bought 500-158 grain lead bullets from Missouri...

Before you buy your wife a revolver, make sure that she is strong enough to pull the trigger in double-action. I am not joking, my wife cannot pull the trigger on any of my double-action revolvers. I thought that she was messing with me when she told me she couldn't do it years ago, but she...

I have had a Shooting Chrony F1 for about five years now and it works fine for what I need. I shoot factory rounds and then compare my loads to the velocity of the factory rounds. When I use the Chrony in the sun, I tape cardboard on top of the shields to make sure that the sensors are...

The copper is applied using an electrolytic process. This is a process where a current is applied using a DC power supply. A copper anode is connected to the positive terminal on the power supply. This copper anode dissolves during the plating process and replenishes any copper that is...

Thanks rcmodel. I think that I will give that a try.

I just received my first order from Missouri Bullet Co. yesterday. The box was completely intact with no damage. I just wanted to post this because I have read on other posts that people have received shipments from MBC and their box was ripped open. Some even lost bullets during shipment.

I use Winchester 231 for loading 40 S&W. It is clean burning and accurate.