Recent content by Carbon_15

  1. C

    new $900 korth

    Looks like your support hand fingers will be awful close to that cylinder gap :eek: Will Korth Finger be the next Garand Thumb
  2. C

    .308 cast bullet help.

    wow...good shootin. and some good data. thanks!
  3. C

    .308 cast bullet help.

    Thanks a lot...I will defiantly pick up a copy I have been loading cast bullets in handguns for a whole now, this will be my first time trying cast rifle loads
  4. C

    .308 cast bullet help.

    Thanks! Any chance you could share the specifics?
  5. C

    .308 cast bullet help.

    I have a .308 mold that drop 160gr bullets. I want to load some of these in my fr-8 Mauser. I have some Reloader 7, 3031, and a little but of 2400 on hand. They will be gas checked, and cast with wheel weights. Not looking for super light gallery loads, but I would like them to be hot...
  6. C

    9mm AR-15 problem.

    I was shooting + p loads. Tried some more today...same issue. Switched to standard velocity loads and the problem went away...odd. Yes...it's a RocknRiver upper and it came with a bolt. It's defiantly not short stroking
  7. C

    9mm AR-15 problem.

    I recently bought a RRA 9mm upper for my AR. The rifle has functioned normally through sever hundred round before the upper swap. In 9mm configuration I basically have a single shot. The rifle will fire, ejects, and loads a fresh round, but the hammer follows the bolt forward. I have the...
  8. C

    Stop wasting you steel cases

    http://m.hornady.com/store/Steel-Match-handgun/
  9. C

    Stop wasting you steel cases

    I highly doubt any manufacturer of automotive wheel balancing weights would recommend My preferred use of their product as bullet casting material...
  10. C

    Stop wasting you steel cases

    well I dont! where I shoot EVERYONE reloads and we also have a few brass scrounges who come by almost every day and sell what they find. I find .223 brass by small handfulls at best. its just nice to know that on the days I dont find a small handfull of brass, that I do have a viable option.
  11. C

    Stop wasting you steel cases

    Thx archangel If only wolf 7.62x39 was boxer primed.
  12. C

    Stop wasting you steel cases

    Steel can be reloaded. I have been doing it for years. There are a few caveats however. - .223 is the only steel case I have found that uses standard boxer primers - you can't use lacquered cases - you can only reuse them once - the steel is a little harder to size and may accelerate...
  13. C

    SBR engraving....where to?

    Im near Columbia SC and wondering where to get my SBR engraved. I would really rather not walk into Things Remembered with a "bushmaster assault rifle" lol Anyone know of a place around here that does laser engraving and is farmiliar with firearms?
  14. C

    Superformance powder help!!

    Has anyone experimented with Superformance in the .308?
  15. C

    Superformance powder help!!

    Thanks!! That helps a lot! At least I don't have to make fireworks out of it :-) Gonna make up a batch with some Barnes 150's later Thanks guys
See more
Back
Top