Recent content by combatinfidel

Keeping environmental records is very important I use iSnipe and it stores my environmental data for my zero and factors it into the current environmental data Sent from my iPhone using Tapatalk

Keep in mind I'm not shooting F class and I don't mean to bring up an old topic but here is three shots from a load I was developing for my savage scout the brass is Lake City (probably mg since the long range 7.62 is makes LC LR). I very basically loaded these rounds cleaned sized trimmed...

Here is the Varget Results not sure when I will get the IMR results I had to go get my daughter from daycare after getting to the range this morning Sent from my iPhone using Tapatalk

Joshboyfuture just wanted to let you know I am headed to the range this morning Sent from my iPhone using Tapatalk

I use a vice at the range that is bolted to the table the stock is clamped into the vice I generally try and eliminate as many variables as possible Sent from my iPhone using Tapatalk

I'm going to try and go to the range this week I'll let you know what my results are like you I loaded three rounds from min to max in half gn increments for each however I am shooting a savage 11 scout in 308 with an 18" barrel Sent from my iPhone using Tapatalk

I highly recommend a chrono because it checks consistency of your loads if you have one group spread out with very close velocities and a low standard deviation than you would want to try another load if you have a group spread out with a difference in velocity and a higher standard deviation...

I'm getting ready to test bar get loads against 4064 loads Sent from my iPhone using Tapatalk

Sounds like a good start I recommend cubbies and shelves peg boards are dated but useful Sent from my iPhone using Tapatalk

FWIW I always check headspace before priming and loading powder and bullets Sent from my iPhone using Tapatalk

I have 4 kids the youngest just turned 1 the cans are great for keeping brass sorted throughout the process as I can only manage to spend about 20 minutes at a time out there Sent from my iPhone using Tapatalk

This is my starting point we will see where and what can be improved Sent from my iPhone using Tapatalk

Here is a photo of my load data sheets Sent from my iPhone using Tapatalk

That is where my system could improve I shoot a bolt action and for the purpose of theses rounds I will be loading one at a time so my "system" remove from box load shoot put back in its spot in the box Sent from my iPhone using Tapatalk

I have my loads ready two different powders starting at the start load in .5 gr increments to the max load for each the only variable is the charge weight just need to carve out some range time Sent from my iPhone using Tapatalk