Recent content by DE50

(L) S&W .500 and (R) Freedom Arms .500 JRH

JRH did the short barrel conversion (from the front of the barrel).

The PC 500 and 4" 500 felt much easier to shoot for an exteneded range session than a long barreled 500 Linebaugh that I once owned. The weight of the S&W 500 along with the hogue grips seem to dappen the recoil very well for me. The only other big bore that I enjoy shooting is my custom...

It is a true four inch barrel 500 revolver. I wanted to thank John Ross and a S&W engineer for their suggestions:) The recoil on the 4" barrel and the Performance Center 500 model feel identical to me. The grips work very well. I have had no problems shooting it using the 350gr and 440gr...

Four inch barrel (no comp) S&W .500

Yes, it is a Ruger 454 that was converted by Huntington. Here is the pic of the Kydex sheath that Jim March made for the Strider knife.

I thought I would post a picture of the Kydex IWB Holster by Jim March for the Super Street Hawk 454. The 625 has wrapped Kydex panels.

Jim's kydex creations are pretty good since they are fitted to the individual. Jim, don't you offer a holster that does not need to be fitted to the individual?

Here is another picture of the other side of the 454. Jack Huntington informed that the cost for the conversion is $450.00. Jim, please check your email:)

Chrono Data The Chrono data for the Super Street Hawk 454 Casull: Chrono Data: Freedom Arms 300gr, flat point jacket bullet - 1414fps Winchester Partition, 260gr - 1486 fps WildAlaska, did you build a 2 1/2" barrel Ruger 454 and chrono'd some loads through it? If so, I hope that you are...

Jack Huntington has built 500 Linebaugh, 500 Maximum, .475 (before Freedom Arms) and has just completed a 50 Alaskan BFR revolver. I wanted one of those but I felt that the Super Street Hawk was more practical. You could ask Jack how much work is involved but I know that this one is not as...

To give credit where it is due, Arron B. (Wildalaska?) is the person who made me aware of the moon clip conversion on the Ruger 454. Jim March, will you make me the IWB holster since I did not have you make me one for the 3.5" 454 version?

This started life as a stock Ruger 454 and than it had a 3.5" barrel. I have a couple of Freedom Arms revolvers but they are single action guns and I have not yet mastered rapid single action shooting in .454 Casull :) This Super Street Hawk 454 was custom built for me by Jack Huntington. It...

I wanted to post a picture of my almost finished JRH Super Street Hawk 454 pocket/packing revolver. It's not a Freedom Arms, but it is a very handy trail / front pocket 454/45lc/45acp revolver. The factory grips work well after a little bit of shaping.

The SSK 50 American Eagle is a 650gr BMG bullett (.510) in a 50 action express case. Recoil is not bad with a good brake in the Encore, but it will get your attention with the max load.