low and behold ! i walked in to my local gun shop and found these on the shelf .i told myself i would never pay these prices for primers ,but impulse buying was at its peak.Now that ive got them they will be everywhere for half that cost!!
Was looking for advice on a recently purchased Spanish Mauser .my son bought the gun so I’m not up on all the details . I think it’s the 1916 short rifle . It was rechambered in the 50s to nato spec 7.62x 51 . He has ran a few rounds through it and it shoots pretty good .my question is wouldn’t...
Just wanted to follow up here shot some factory loads to get on paper and the gun did well . Switched over to some handloads ( 40 gr. H4350 over 95 gr nosler ballistic tip ) gun shot a tad bit lower but had a real nice group the pic is 3 shots . That will be my hunting round .keep in mind this...
I have no issues with the quality of their bases ,in fact i have rifles with weaver bases that ive hunted with for 30 years and no problems .an allen head or torx screw would be nice though!
Thanks guys i did get using a tiny pick and even a sewing needle on one of them.the scope is all mounted .On a side note weaver should get with the times and use something other than flat head screws ! i mean who even uses flat blade screws anymore:(
I picked up my new tikka tx3 and am now ready to mount the scope. I’m having issues with 3 of the 4 scope base mounting screws . The one screws in nicely with my fingers but the other 3 are very difficult to start. I’ve read a bunch of stuff on this issue and it looks like the likely cause is...
I watch the thread “ where are the reloading components at “ here on the high road fairly often but never seem to hit it just right when they are available . I do see quite a few now available on various sites on the internet but don’t recognize the companies selling . Are there more places...
I’ve had time now to get in my loading room and organize some things. Feel dumb even asking the original question because it’s visually obvious what was in the powder measure now that I’ve had time to look at it .I will be much more organized in the future though.as seen in the pics it’s the...
I only have 4 powders right now it comes down to iMr4350 or h4350 . The two powders are very similar but I’ll do as suggested and just toss it .about the log book ( I wish I knew where tf is and I wouldn’t have asked the question )Thanks for the replies
I have a quick question . While doing some reloading last year I left some powder in my powder measure and now don’t remember what it is . I always make it a point to dump it back into its container when I’m done reloading ( but not this time ) I only have about 4 different powders on hand so I...
I did settle on the tikka t3x lite it seemed to fit the parameters I was looking for . It may be a tad heavier than I was hoping for once the scope is mounted but still plenty less than my 3006 . I bought some factory ammo for it and I will run some of my handload stuff through it as well to try...
Wow that storm is light ! My son in law has a savage axis in 308 and is very happy with it . Would be great if they had one I could check out at the gun shop
Thanks to everyone for the replies. I am solely hunting white tails with the gun and I’ve done a lot of reading on the tikka tx3 . That gun surprisingly is heavier than the 308 due to the longer barrel . I’m going to my local gun shop tomorrow to look at a few models they have .where I hunt you...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.