Recent content by dhg2

Taliv, Wow, you are sure taking your time at 5 to 6 per minute. When I get cranking for a big batch of 2k or so, I run over 20 per minute with peaks as high as 35 per minute. I think you can safely speed up your process if you choose to do so. 1200 per hour is not really pushing it once...

My webiste is www.giraudtool.com. From there you can navigate to the trimmer page and find all the info you need. At the bottom of the page is a link to the instruction manual in .pdf format. Feel free to download a read at your leisure. Thanks, Doug Giraud Giraud Tool Company

jmorris, If you want cases deburred and chamfered, the Dillon isn't even close to a Giraud. If you want just blastin' ammo, then Dillon is perfect for that, but for match ammo, deburring and chamfering is a necessary step. Doug Giraud Giraud Tool Company

Not needing to chamfer the inside of the case mouth is not something the tool manufacturer should be making the call on. The reloader needs to make that call themselves and choose the equipment to match. If you are loading bare copper bullets and not concerned with damage to the base/heal of...

Static mitigation... I know it sounds goofy, but it works for me. Take a "bounce" fabric softener (dryer) sheet and wipe your whole powder measure assembly from top to bottom and then tape it around the powder reservior. I change it about every six months. HTH, Doug Giraud www.giraudtool.com

djl4570, There is no need to worry about a lock nut damaging your case holder. If you can damage one with a normal reloading clamping lock ring, I will replace it free of charge. I seriously doubt that a single 6-32 screw will compress the stainless case holder before the screw strips or...