Recent content by digid

I would like to add to some of the comments that have been made to my post of throwing issues with this measure on the turret. My bench is rock solid, does not move at all. At one time in its life it held metal working equipment in excess of 1000 lbs. Yes it was my first time loading on...

I used mine for the first time tonight loading up some 357 mags with 2400. It was very consistent during testing, but once I put it on the lee turret it would throw about .3 - .5 high with the turret going around. (I was working up some test loads so weighed them all.) If I dumped them and...

Titegroup, and Power Pistol is what I use the most, and I only load xtreeme 124 for 9mm

I also have a 550. I de-prime on a Lee single stage with a universal de-caper before I tumble. I do this for a few reasons. The main reason is the primers are dirty and contain lead dust. I do not want that in my tumbler or in the air when I separate the brass from the media. It also keeps the...

You did not say what press you are using. In my Dillon 550B which is a 4 station progressive I find it changes a bit if I do not have a cartridge in all 4 of the stations. Especially the sizing station which is directly across from the seating die. . I also changed my set up so that the bullet...

I found using Trail Boss in a 38 Special with 158 SWC that too much of a crimp was causing my bullets to not be as accurate. Now these are light loads for paper. If I do a very light crimp, just enough to remove the bell and maybe just a little more I get better accuracy. Never had a problem...

I have loaded over 1500 380's for my wife and I, using xtreme plated 100g with titegroup. They have shot very well in all of our 380's. I was concerned about the small amount of powder in the cases, and even more about the small spread from min to max using TiteGroup. I also tried it with some...