Considering reloading this round . i have read that is a hard round to load because of the short bottleneck . however l reload 762x25 with no problems. Looks to me like the bottleneck is about the same length.
Problem is, try as I might I cannot budge the extractor pin. Looks like it is maybe soldered in at the top. Thought of trying to file the top of the pin off with the understanding that it would require refinshing the slide after completing.
Having failure to eject issues with my TT-33. I've owned it for several years and had issues in the past with factory ammo (PPU) started reloading and made up a test load with 5.8 grains unique under a xtp 90 grain HP. Fed fine, good accuracy but 2 of the 10 did not eject. Any ideas?
I pick up brass from my range. I have enough 9mm to last for years without twice firing. 40 a little scarcer but not bad. Lots of zinc coated 9mm. I figure if someone is reloading, they wouldn't leave brass laying. Especial zinc. Just can't figure who would be shooting hollow points at the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.