I don't see a need to vacuum seal, but sealing in heavy plastic and just removing enough air to flatten it out would make it easier to pack for camping etc.
Picked up my CZ457 Precision Varmint from my guy. Waiting for the 11mm dovetail to Pic rail adapter from Area419 so I can mount a scope and go try it out. Also picked up three extra magazines. They are all 5 round, so looking for larger capacity magazines.
Brass Magnet
I bought one of these many years ago. It does work. The edges are weighted so it does not lift in the wind. And as it's mesh any dirt or sand falls right through.
I suspect it's the same netting used to cover dump truck loads.
I have FF3 on two of my 22 pistols. One is a Mk4 22/45 Lite. It's mounted on an Outer Impact plate that allows the sight to be as low as possible. The other is a S&W Victory with the same mount. Both are 8MOA and mostly used for shooting steel at moderate ranges.
A fellow at my local range has a complete set. Bowling ball, Billiard ball, and Golf ball. The Billiard ball model also shoots soda cans.
Lots of fun. The whistle from the bowling ball finger holes is really cool to hear. Maybe we should drill extra holes of varying diameters and depths. Maybe...
This is the set of Ghost Stryke ears I received yesterday. Got what I suppose is a deal @ $200 for 2 sets. They've got Bluetooth which I don't plan to use at this point.
I used them some today while evaluating prospective members at my club. They shot AR and bolt rifles in 223 and 270 as well...
I've had a set of Nitro Ears for a few years and they work very well. In ear hearing aid style . The maker did a hearing test and incorporated a little hi frequency boost. They are not cheap at $1100. I almost lost them once and was quite upset but they were found.
I have a set of Iso Tunes...
My M&P CORE has the sear lever and I sometimes use it. It's a little hard to reach without a screwdriver or pick. But I can see it's usefulness as an additional effort at safety. My XDm had a similar system, but I was replacing some parts and forgot to reinstall the part. Still haven't done so.:(
Just ordered another Pocket Locker for my P365. My original one did not have the "tab" for pushing the holster off while still in your pocket. The one I'd bought for my P938 did. The tab on my P938 holster is bent off to the side, but apparently the newer design just leaves more Kydex protruding...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.