You were lucky.
I fired a.8mm Mauser with corrosive ammo and let it sit until the next day. I spent the day punching out red rust from the bore. Fortunately no permanent damage.
Depends on what you're using it for. I was a LE firearms instructor and I've seen guns so dirty they couldn't get through a magazine without malfunction. Moreso in the cold.
Not amazing.
First, take a look at inflation.
Second, take a look at population
Lots of more people wanting these guns.
Supply and demand.
Finite numbers of these firearms out there.
I've no experience with the Ruger.
I have a 21A that I sometimes carry in a low threat environment. I carry it hammer down safety off.
Reliability? I use CCI Mini Mag solids. You are going to need penetration with a small caliber gun. I take it to the range once a year and fire Mini Mags...
I never cast bullets. However I've found the 200gr H&G bullet which became my standard 45 ACP bullet. Over 6.0 grs of Unique (well under max) it gives me 900 fps. A good all around 45 load.
I'm not a hunter but do have 2 favorite 30-06s.
First is my VAR barreled Garand. Shoots under 3" @ 100 with any M2 ball.
Second is my sporterized 1903A3.right. Got it cheap as the original barrel was cut and receiver was drilled for scope mount. No resurrecting this to an original. Whoever...
Another vote for Mobtil 1 grease.
Unlike petroleum based greases it doesn't harden. I have Garands I've greased up and put away years ago and the grease is still as soft as when I applied it.
I have a 1980 Guns and Ammo publication titled "Guide to Assault Weapons".
Prior to the late 70s early 80s, if you wanted a semiautomatic rifle that fired 5.56 you had your choice between an AR or a Mini 14.
About 1980 there became a huge choice of semiautomatic rifles styled after military...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.