Recent content by hang fire

  1. H

    Marlin leverguns, back in the game?

    I knew Lucky Wade when he had his gun shop in Phoenix, nice guy and a terrific gunsmith.
  2. H

    Found a Japanese type 38 intermediate rifle this week

    Good score, those Arisaka rifles have a very strong action and getting harder to come by all the time.
  3. H

    Marlin leverguns, back in the game?

    Marlin and Remington in early 1960s stole the .44 Van Houten Super design from Van Houten and Lucky Wade in AZ.
  4. H

    Marlin leverguns, back in the game?

    For $1580.00 msrp, Winchester Repeating Arms (rolled stamped on bbl) has come out with their 1873 rifle in 357 magnum/38 special.
  5. H

    CBRPS Mosin Nagant Cossack

    Pre-bubbaed Tula $25.00, $8.00 11mm to Weaver mount, $40.00 LER pistol scope, $30.00 aperture sight, $10.00 rubber butt plate. I removed rear sight base and utilized 12mm dovetail, blued the steel, made a leather cheek piece and stained the stock. Toal cost$113.00
  6. H

    Anyone into MilSurps and reloading for them?

    The answer to your horizontal question was as posted here: Mas36: For windage the front sight is only soft soldered in the dovetail, little heat and it can be easily drifted.
  7. H

    Anyone into MilSurps and reloading for them?

    If it is a Mas-36, perhaps you could enlighten me as to the differences. If you are referring to rear sight, merely press down on aperture and then shim as required with paper, plastic, brass, or what ever.
  8. H

    DHS says people with handguns, rifles, and shotguns may be terrorists

    All too true, that is why I do not trust any DHS people bearing arms.
  9. H

    Anyone into MilSurps and reloading for them?

    Methinks you speak out of turn there. Most reloading books will caution against loading thicker wall military surplus boxer primed brass with loads listed for commercial brass, without working slowly up to them.
  10. H

    Anyone into MilSurps and reloading for them?

    Mas36: For windage the front sight is only soft soldered in the dovetail, little heat and it can be easily drifted. The rear sight for 100 yard or less elevation, can be shimmed to lower aperture.
  11. H

    Anyone into MilSurps and reloading for them?

    I will not attempt to improve on your post, as it boils all down to it's essence.
  12. H

    mosin finnish 39 shot yesterday.

    I reload and shoot cast boolits in all three of my M39 rifles, like they were made for cast and all are scary accurate with them.
  13. H

    New EPA Regs Force Last Lead Smelter in USA to Close

    http://www.stltoday.com/business/local/doe-run-workers-to-be-cut-at-end-of-december/article_56182c9f-0413-59a5-865e-e864715f3c2d.html October 16, 2013 11:00 pm • By Leah Thorsen [email protected] 636-937-6249 HERCULANEUM • About 145 employees of the Doe Run lead smelter have...
  14. H

    Mauser Action For Rifle Build

    Get one of the cheap Turkish rifles with the large ring action, but threaded for small ring Swedish Mauser barrel. A 6.5 Swedish Mauser barrel will fit like made for it. https://www.google.com/#q=Turkish+98+Mauser+with+a+swedish+mauser+barrel
Back
Top