Recent content by Harleytoo

I got the mount in from Griffin Hill and low and behold Bass Pro had the Vortex Venom on sale for $150. Also got in a Hogue grip, so phase 1 is done. Trying to decide on if I still want to cut the barrel down. I can tell you right now, with the Red Dot on it, is is shooting one hole groups...

Thanks guys

Does anyone know of someone they could recommend to cut and crown a revolver barrel in Texas, preferably near Dallas, but I am flexible.

The question is Vortex Viper or Venom?

I decided to get the Griffon Hill reflex mount. After looking at the scope mount rings they were going to put the scope higher on the gun than I wanted. I had been thinking about getting a Vortex Viper for it to begin with. I think this setup with the shortened barrel will be optimal for how I...

Thank you. I sent them a note just now about how it mounts on the Super Redhawk.

Yep, I have seen that one but I can’t find a single picture or comment of anyone using one.

CraigC, this is most probably the setup I will end up going with. So the 30mm fits just fine in the stock rings?

What I don't get about those mounts is that they are longer than the top strap. I guess I could cut it down.

Here are a couple of pictures I found that show what I am thinking about from a scope and barrel shortening standpoint. That is if I cannot find a good reflex mount. Actually also have that Hogue grip inbound as well.

Aside from the range, if I were to carry it it would be in a cross sling chest holster if I were hunting. That is actually why I wanted the reflex sight for fast acquisition. Here in Texas brush it would be a good hog gun I think.

Yea, I think just cutting it down a bit would be all I really need. I meant to post a pic in the original post. Put it there now.

I have been looking for a revolver and was planning on picking up a switch cylinder 45LC/45ACP but happened upon this 10mm Super Redhawk. I have a bunch of 10mm and 40 S&W that I no longer had a user for and ... this. Anyhow, my thoughts were to put a red dot reflex sight on it but I am finding...

Yea, the best bet right now is to sell off what I don’t need any more and just hold out till prices come down. I would prefer to build a 300 BO AR Pistol.

Even if I down size I will still have 9mm, 357 SIG, 38 Special/357 Magnum, 40 S&W and 45 ACP that I will shoot. I have components and brass for other calibers as well, but that I no longer own. The concern over the cost of some rounds, like 300 Blackout, are of some concern. However, I do have...