Recent content by kostyanj

Just shot this last night. Quite happy with the load, very accurate and no signs of high pressure. I'll back it down to 4.1 just to get it within new load data.

Thank you. Like I said I'll report back later this week.

Thank you for that. So the load is towards the upper end but not out of bounds. My concern is with oal. Seems like mine is slightly shorter than the tested. I'll chrono a few and see where they land.

That's from Reloader's Reference 9.3

I see imr data says 4.7 under a 115gn jhp.

I just wanted someone to double check this load. I have 115gn plated rn bullets over 4.3gn of 700x with an oal of 1.13. Anyone see any issues?

Slightly OT but related. If you're running a bullet feeder die, do you run a powder through expander? Reason I ask is because I really like using the powder cop and don't want to give that up to put the bullet feeder on. The only way to have enough space would be to run the powder through...

Normally closed pressure switch comes to mind. Or something like these http://www.smarthome.com/7113/SECO-LARM-SM-200Q-WH-Surface-Mount-Magnetic-Contact-Switch-Normally-Closed/p.aspx Sent from my TF300T using Tapatalk 4

Buy one used. I recently bought a whole setup and after I sold off what I didn't need, I paid 200 for the press with 4 sets of dies, shell holders, brass, and bullets. So there are deals out there, just keep your eyes open. Sent from my TF300T using Tapatalk 4

How do you like the trigger on that ruger? I keep going back and forth between this and a 686/586

Did you shoot indoors? Tumbling ammo wouldn't release much dust.

Bookmarked for future reference

The main concern for lead is that which is in the primer. They are made with lead styphanate. Elemental lead is not very easily absorbed and needs to be inhaled or swallowed to have any effect. That being said, it has a cumulative effect and builds up in your body. I might be overly cautious...

20000 rounds through a glock is just getting warmed up. Replace the springs and go. Glock has a lifetime warranty and will rebuild it if anything fails.

My original post in this thread was made against this comment and it got derailed from there. I was just alluding to the fact that 147 can ONLY have the lowest recoil impulse IF the force (F=MA) is less than any other weight. This led into a discussion on acceleration (how pressure affects...