Any concern with a squib going this low? In the same boat here with a 6" 44 magnum. I've loaded down to 9.6 grains of CFE under a 240gr bullet. Would be nice to bring it down a bit more.
Awesome, both of those things make sense and I bet i'm making the problem worse.I have steel dies and have to hit the brass with OneShot lube to resize...and I bet some is getting inside of the case. I will tumble the brass after sizing to remove all the lube and tumble those bullets.
If I went...
I just loaded my first 10 or so 50AE cartridges. 31.5gr h-110 under a 300gr berry's projectile. Rounds cycle fine. I seem to be having trouble getting the correct neck tension with my RCBS dies. I thought I had enough by trying to push the bullet in once it was seated on the bench but the recoil...
It appears someone left in frustration a couple hundred 300 blackout in the brass bucket at my local range. The necks are all crushed. I'm sure they were reloads with the seating die not set correctly. I'll be pulling these as most of the bullets are in good shape(the photo does not do most of...
What a bummer. I've learned a lot about reloading reading here. I figured out quickly if it was posted by rcmodel it was solid information. Thanks for your contributions. RIP.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.