Recent content by masood

what other powders are in the IMR 4064 range? I do have IMR 4046 as I mentioned my my earlier comment which I am loading now. just a mag. 6 rounds. I also have Win 760, Norma URP, RL22. I had very bad experience with H-380.

Also, how can I find a Hornady comparator or other brands for Swiss 7.5x55?

THanks Lencac for your reply and recommendation. I do have IMR 4064 and will load a mag or two to see how it will improve my experience with K31 (accuracy and speed). Yes, i noticed some built up in the vase using H4381SC, not much tho but still. I will post result of new loads using IMR 4064...

I used berger 168 vld bc. G1 .498 to OAL of 3.03 max . 2.99 to 3.03 with good fit. 3.06 ceated a bad jaam. I used Fed mag primer and h-4831SC goof grouping at 100 yards but chorno give and ES of 110 in 20 shots with Avg velocity of 2042 fps. Hogdgon lists 2477 for 45 gr start load of h4831. My...

Thank you T. I will get at it now! -m

thanks for the Link.Tyeo098. I certainly watch the video. -m

Thanks RC, yes I have seen a wooden plug inside it and I was wondering what a peice of wood was doing in a shot gun Mag? I know now and thank you. -m

Thank you All. ho wdo I remove the cap on teh Mag if you may please? I haev taken out the barrell so i know that but have not touched the Mag just yet. and thanks for the good advice. its always best to stay legal but on the other hand one has to kno whow to remove and when needed put back...

hello All, I purchased this Mossburge shot gun 500, 12 gage from a gun show and the seller + th emanual says it takes 5 shells in the Mag and one in the barrell so a total of 6. the first time i tried the gun in the range i found out that the Mag takes no more than 2 shells! + 1 in the...

Put the barrel in by sliding the internal parts in using the release lever (I don't know the technical terms) and locked it up. it tested it "without the snap caps" of course and it seem to be firing well. the safety on is also working so it should be working. Now I need to really fire real...

Ok Removed them. brought them out. 1- took the barrelle out 2- used a bar and slightly pressed on a bar inside the received and that pushed the snap caps little out. 3- now, I pressed at the edge of the graber or I think th eextractor and the snap cao poped right out. so, this may help...

inside the receiver I can see a long "wodden" bar! seems wodden but not metal. I am trying to find something thin but strong and long enough to push the snap caps out! let see if this will work!? thx, masood

Took the barrelle off but still cannot take those shells out because the are in teh lower tube or the mag. I can push the snap cap in "forward" spring acton but not Out. I don't see any broken part of the Gun or bent part either. still trying to see how I cna remove thos etwo snap caps out...

Hi Juk, on mu shotgun I removed the "Nut" or Cap scrw on teh top of the Mag barrel and looked inside with a flash light but I don't see any bars. I do have a Moss 500 shotgun - they might be different although same modle. so you guys suggest I remove the barelle to be able to remove shells...

here is the same story someone else had posted under reviews for which Aristodemus posted a link. "Awful. Tried these in my Maverick 88 (Mossberg 500). Worked fine first time. Second time, got STUCK in feed tube....base had been distorded by extractor, and left chips which jammed in tube...