Recent content by mdripley

I have two Lee Classic Cast Turret Presses, along with Dies and extra turrets , as well as Auto Disk Pro's for 9mm, .357 Mag., .45 ACP, and for .223. This has been the best spent money in my own experience. Easy to set up and use.

I am willing to bet that all major suppliers are maintaining low inventory stocks coupled with high demand equals long lead times and higher prices JMHO

There is a separate Rifle Charging riser that you must purchase. It allows the case to activate the autodisk powder drop, without expanding the case neck, also you may need a double disk adapter for the autodisk to give enough Powder capacity to the charge cavities in the powderdisks. all are...

I have been using the zip tie trick for over 2 years now and have not had the priming arm drop out since.

Thank you very much for the input, I really appreciate it.

I will add that, I am loading these for use in a GP-100 6" barrel and a Marlin 1894 with 18.5" barrel

Hello everyone I have a few questions for those of you who may have used the MBC .357 Striker RNFP and .358 #1 ranger bullets. I have 5 different, all current reloading manuals and I cannot find load data for 180 lead bullets, my question is I can find plenty of data for Jacketed bullets...

Both cost and the ability to load ammo that I cannot purchase off the shelf. i.e. for my AR I load 68gr hpbt match and my AR loves them, I cannot find anything close off the shelf at a price I would call affordable.

sprinkle with fairy dust, put on a pair of red slippers and tap your heels together three times.

Thanks RG1 and everyone else who has posted. That is exactly what I needed. Now I will load some out to test drive so to speak

I think you guys have summed it all up pretty good, I have 2 LEE classic turret presses and one single station press. I had a little bit of a learning curve to get everything working correctly, i.e getting my dies set up right, learning to use the safety prime, etc. I now turn out excellent for...

I cannot locate any factory loaded Golden Sabers to Measure, Hence my question as maybe someone here may have some that could be measured. I have reloaded plenty of JHP with crimp channels. I cannot locate any pictures of factory loaded GS either.

Thanks very much for the illustrated information, this is just what I needed.

The title pretty much says it all I am asking if anyone here can tell me what the factory loaded OAL is for 38SP + P, TIA for your input it is greatly appreciated.

My simple solution was to but a Lee Classic Turret press and not look back, it is a much better press, sturdy and precise JMHO