Recent content by MifflinKid

Check page 45 for 158 grain LSWC load information.

Ruger P90. The only time it faltered was when I fed it with some reloads, I did not properly remove the mouth bell.

S&W PC 625 4". I love shooting this.

I believe current approval times are more than two months. The folks at Maryland Shooters have been doing a great job tracking the entire application process times since last summer. There are 442 pages of tracking posts...

Submitted 7/17 Accepted 7/18 NICS 8/03 Approved 8/17 Got the email at 5:27PM Received 8/22

The drone operation was great. It looks like a nice facility.

I have both - blued and nickle plated. The surfaces you are going to touch are not going to be seen until you open the action. On my nickled gun I keep the smoothed surfaces lubricated with grease to prevent rusting. On my blued gun I did cold blue the portions taken down to the bare steel...

"do you think the occluded hollow points can affect accuracy?" Only a proper science experiment at the range can answer that question.

At the range I shoot at most often the target backers are homasote. https://www.midtownlumber.com/what-is-homasote/

My P10C is the gun I intend to carry when my Maryland Wear and Carry license application is approved. I used it in my W&C range qualification test scoring 117 of 125 (93%) using Winchester white box 115 grain ammo. I have put in several Cajun Gun Works components since I bought it in 2018. The...

File the front sight down to raise the point of impact for that load.

My hat is off to salute you. Good job.

M1919 - I shot it years ago on a military fort. It was privately owned but the owner wanted to shoot my new-on-the-street Ruger P90. He let me rip off a few dozen rounds in exchange for shooting a box of my reloaded .45 ACP rounds. I got the best part of that deal.

Bravo to you. It looks very serviceable. When are you going to try it out?

I cannot find a list of the 'social media' that are supposed to be checked. Has that list been defined?