Recent content by NCWalrus

  1. N

    Dillon 550 tool head pins not seating fully

    Tool head groove is clean and dies line up. Even with the toolhead removed the pins do not fully go into the press. I'll try to post photos later
  2. N

    Dillon 550 tool head pins not seating fully

    I have an older Dillon 550 and the tool head pins do not go all the way in to the top of the press. They sit up an inch or so over the tool head. Has anyone ever experienced this and know of an easy fix? Thanks
  3. N

    Show us a picture of your reloading bench

    Impressive set ups in this thread! Makes my garage setup look ... Humble ...
  4. N

    Help with first revolver purchase..S&W 617

    I appreciate your help
  5. N

    Help with first revolver purchase..S&W 617

    I am looking to buy my first revolver, a Smith & Wesson 617 .22LR 4" These guns seem very hard to find and overpriced where available. Does anyone no where I can find the best deal on one? Thanks for your help
See more
Back
Top