Recent content by NDArmyGuyret

Got to the range again today and concentrated hard on trigger pull technique. I gave it a squeeze and held it and the second shot goes off so quick and then I release the trigger. Digging deeper, the trigger pull is quite hefty (as it should be..above 6 lbs), the buffer is very close to all my...

Update: changed out trigger group and put in another set I had. To the range. Did same thing. Using factory IWI 5.56 ammo and the primers look normal. Cleaned the BCG and will try again.

New AR is popping off two rounds with single trigger pull. I've looked at the lower and it's the same as my others. Is this a gas issue or something else?

Is there a hex or screwdriver slot on the one end? I'm thinking by the size of the part it may be for your AR. Just a guess...

Yes sir! That's it. With that I can figure out how it's supposed to go together...Thank you!

Thanks, but already have that schematic in several books...The gun in question is a break action and has a small lever off the side of the hammer that is pushed down to open the action. The biggest problem I see is what order do the parts go back in...?

Already tried Numrich's...Could this gun be a copy of something older, maybe?

A customer brought me a 'basket case'...A Rossi 410 single shot shotgun (believe the model is an S411) a lot of parts there..a schematic or video could get me started. I guess he caught me at the right time or I would have said 'no thanks'. But I am open to challenges. Thanks for any guidance!

Thank you for the information! Very helpful!

Need to identify this 12ga shotgun. Has 33" barrel with 'Hunter' stamped on it, a flip open cover with a 4 digit number stamped on the underside. It will not take a 2 3/4" shell readily, so I think it's only a 2 1/2" chamber. Any help would be appreciated!

Update: did some more digging and found that it is indeed a Stevens model 315. Have a part listing but no schematic.

I have a Stevens 311 variant side by side shotgun on the bench that has cocking problems and the underside of the barrel has the cocking plunger and extractor along with a part not shown in diagrams that slides back and forth. Diagrams show a spring also (missing). Anyone have an idea on the...

Update: Took a deep breath and tried it again and it slid together without a hitch! I function checked it and test fired and all is well!

I have a Browning BL22 that needed a heavy cleaning and disassembled it and all went well until I tried to slide the bolt assembly into the barrel and tube assembly. Problem: the ejector spring keeps falling out and jamming. I've wrecked two springs trying to slide the 2 sections together and...

I believe you're right..I took another look and the plunger at the end of the tube stops about +/- 3/16ths of an inch short.. I am going to try to extend the plunger by gluing a small puck on it to see if that pushes the cartridge out a little more so the carrier will clear..Won't get back to it...