Recent content by NickAlbion

Tks Mike. the Arbor is too long. this gun is a combination of parts that I will hand fit.

tks looks like I will be using my diamond files.headspase is .018 and should be 006.

looking for the overall length of a uberti 1847 colt walker cylinder. I am building an ASM 1847 colt walker using parts from multiple sources. I think that the cylinder I last purchased may not be ASM.

I am looking for a barrel wedge for an ASM 1847 Walker

The following measurements are for the Uberti 1847 barrel wedge. the thin end is 0.561” wide The outside end is 0.626” wide The overall length is 1.3375” Overall thickness 0.157”

do you have a way to measure the width of the barrel wedge wide end and small end? The ASM wedge is larger than the Uberti. by about .060.

If you believe that! then I have a deal for you.... a brass framed 44cal confederate Griswold and Gunnison.

tks everyone for your responses and ideas. I did find the pins available at taylors firearms. turns out uberti pins and ASM are the same size.

Any one have the diameter for Uberti walker barrel line up pins?

asm 1860 Does anyone know where I might get an ASM 1860 steel frame?

tks tks for response.

I have an ASM/CVA 1860 barrel. looking for a steel frame. was wondering if this barrel will fit on a 1860 pietta frame?

Add me to the club

I just added more photos? could this be a real tyron and not a reproduction?