Recent content by Nosidda Zneas

Nothing?

i bought this mag release about two years ago and would like to add one to my DRACO but every search just brings up EMA's release or the metat AMBI release. Can anybody tell me where i could find one?

:eek:

I am customizing my yugo sks. I was wondering if a russian sks or any non squared yugo style gas block will fit the yugo sks?

Texas weapons systems has a Gen II rail out on full production, from all accounts it retains zero even repeated openings. Has a low rise so you can aim like you normally would and not have to raise your cheek like other models http://www.texasweaponsystems.com/id1.html

will these work on cetmes?

heres mine i used aluma-hyde2 i went for the russian coating look to get the look i held the can labout 1.5 feet from the surface and it gave it the textured finish and as you can see its a thick coat

what from the river bottom before the cops find them? J/K

nv just saw other thread

going to get that Hogue!!! been looking for an after market grip for my KAMA

same here had to shave it also just made a heavy gun heavier cool looking though just dont have any optics for it

myth is right i had read that the cases did not melt so i tested it, i pulled a 7.62x39 round fired the primer in my ak and took a torch to it and at no time did the coating melt! it just turned black and carbonized but only after a minute of doing that

cass sunstein look him up

what about a ubr?

W.E.G. thats a beautiful picture