Recent content by ohman11

  1. O

    Pyrodex advice

    I guess one of my concerns is because I am using such a heavy bullet in it, IT seems I had read sometimes it's less powder for a heavy bullet.
  2. O

    Pyrodex advice

    I got the gun used so no manual, I am pretty sure it does go to 3 pellets from what I have read.
  3. O

    Pyrodex advice

    I am going to try out a new rifle in the morning and if I like it I may hunt with it this season. I have a CVA Wolf 209 Magnum. I am going to use Pyrodex RS FFG. I have cast some 354 grain minie bullets and was wanting some input on how many grains of Pyrodex to start with. I want to start...
  4. O

    Oops- I hope this isn't a problem

    I agree with RC, I think you should dump it just to learn a lesson. Paying always makes me remember. On the other hand I know times are hard and it hurts to dump 20-25 bucks on the ground. I have a feeling you wont make this mistake again:)
  5. O

    so whats your preffered method to storing primers?

    This is not a great idea but I have a few thousand that my FIL gave me and they have been in his garage for over 20 years just in the boxes they came in. I have used maybe 500 so far and never a problem. I think they are a little more resilient than we think they are. I am not suggesting you do...
  6. O

    Minie Bullet Lube

    Spur I got away from the alox because it is so sticky. If you get a chance try Rooster Jacket. I use it my pistol ammo that i cast
  7. O

    Minie Bullet Lube

    Griz are you just rubbing some on as you shoot them or what?
  8. O

    Minie Bullet Lube

    Well I am going to try some Rooster Jacket on some and give it a try, if not I will go the bees wax route. Thanks for the replies.
  9. O

    Minie Bullet Lube

    I am casting these because I refuse to pay a buck a shot for the Sabots and such that are available. The ridges on the side look like the Lee tumble lube bullets. What are you guys using to lube these? How do you think Rooster Jacket would do?
  10. O

    Dillon-Hornady Swap

    Never had a Dillon but I have had my Hornady for a few months and I like it a lot. Cant compare the two but I know this is a sweet press and Hornady service is great. On a side note, someone said most guys tell the new re loaders to start with a single stage, this is the WORST advice you...
  11. O

    9mm and Herco

    Do you think 5.5 is a safe starting point for a 125 lead bullet?
  12. O

    9mm and Herco

    Sorry It is 125 lead round nose.
  13. O

    9mm and Herco

    I did a search and still didn't come up with a answer. I have found several sites where they are using 6+ grains of herco in a 9mm luger. I was doing some testing and 6 almost fills the case. Hornady manual says 4.8 is max. Give me your thoughts on this.
  14. O

    Ruger "The last cowboy" .32H&R

    You are right Talo did it but there is very little info floating around about them.
  15. O

    Ruger "The last cowboy" .32H&R

    I have a guy trying to trade me one of these and I can not find a value for it. It has never been shot and he is saying it is 100% Anyone have any ideas or information on this pistol?
See more
Back
Top