Recent content by oldfarts

Yes, I saw that after I posted, Wow, Im sure not all here this morning. LOL Thanks

I am having the same problem with the ram pulling out of the carrier after resizing and depriming. What holds the ram in from the factory. Is there a set screw or something else. I am using carbide dies, I clean my brass, and Im loading 45 acp, Press has only loaded 200 rounds before ram pulled...

Its not exactly loose, Its screwed into the expaner die about halfway, I can move it back and firth but it wont come out. The disc are correctly installed. If I turn the seratted ring on the powder unit on the part that goes into the die to tighted it all the way, then the hole gets way out of...

oldfarts I will take a picture of it tomorrow. I have a workshop out in the back and its cold out there right now. Tomorrow I will go out to load my box and take some pictures of the way its set up. It has the chain, but that broke right off when it wasnt working right. The last 50 rounds, I...

oldfarts Thanks for the input. Here is what I found out. I took the powder measure off again and checked everything, graphite where the seal to the hopper slides and as I was putting it all back on my press again, I noticed as I was turning the thumb ring to tighten the powder system onto my...

I recently purchased a Lee pro1000 for the 45 acp. Everything seems to work except the powder measure. Here is whats going on. When I install the proper disc, making sure I put the slot on the tab of the lever. Fill the hopper and turn it on, start the loading process. The powder doesnt fall in...