SDC: The is an engraving of a dog (like a pointer) over the words Ithaca Gun Co Ithaca NY. I tried to get a picture of it, but it is really faded.
Two Old Dogs: There is a letter "F" over a 16. How does this correspond to the letter grade? I have attached a photo.
Thank you both for...
I have a 16GA Ithaca Hammerless SXS. The S/N is 449XXX. On the right top of the receiver is the S/N. On the Left top is a "F" above a "16". There is an engraving of a hunting dog on the side of the receiver. I know there are different grades, how can I tell what grade mine is? i.e Grade No...
I have a Ruger Model 77 Mark I that was made in 1978 and I wanted to know what variant it is. It has a front sight, Two drill holes about 3/4 from the muzzle which I assume was for "Rear" sights. The top of the receiver looks rounded. I am thinking it is a Model 77ST, but I also heard that...
Thank you for all the replies! I have learned a lot about the P38 in the last few hours. Based on the S/N with the G suffix I am thinking it was an AC 42 2nd Variation at the start. And yep, the armoloy ( :) ) finish and the obliteration of the "P38" and "ac - 42" markings make it a poor...
The Serial Number that is on the left hand of frame is also right underneeth the barrel on the front of the gun. The magazine has a different Serial Number on it. These are the only places where I see a serial number. On the left hand side, the 359 is right next to the serial number, on the...
I have a Walther P38. SN 7XXX G. The only other markings on it are of a eagle with 359 under it on the frame and slide. It does not have the Walther banner or stamped 'P38'. Anybody have any information on where, when and who made it?
I have a Enfield Pattern 1914 that was made by Winchester. I see in the Blue Book that Winchester MK 1*(F) with fine adjustable backsight commands more money. How can I tell if I have a MK 1*(F)?
Thanks for the info Savage99. I tried to rotate the objective to 25yds and still had items fuzzy at 25yds, but I could see at a 100 yds clearly on the same setting...
I have a Rem Mod 700 in 22-250 and it has a Unertl Scope on it. The Scope is a 2 inch target model purchased in the early '80's. When I sent a couple of shots down range at 100 yds I was way off. I moved the target to 25 yds to better walk it in, however, the target was blurry. I am unfamiliar...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.