If you want an accurate fit and measurement, you need to use a case that has been fire formed fire formed in your chamber and not a generic Hornady's modified case. I would be carefull using anything other than a lathe collet because you run the risk of distorting the case. Either send a case...
As mentioned by Dale Allen, your die choice should be based on the type of ammunition you are looking to produce. If you just want it to go bang, buy a set of Lee or RCBS dies and call it a day. If you are looking to produce precision loads that are very constant and have very little run out...
They are also extending that limit for 7 days. That means if you buy a brick and it comes back in stock within 7 days, you cant buy it. Also, take a look at their prices now. An 8# jug of H4350 sells for about $216 at PV and is now $287 at MidwayUSA. Very disappointing! :(
Natchez Shooter Supply has H4350, H1000, and IMR 8208 XBR in 8# jugs in stock now. However, they are not able to process online orders so you will need to call. The recording says you are caller 44 and the wait time is 36 minutes but I have called 2x and it was less than a 5 minute wait. You...
CCI #00, CCI 350, and CCI BR4 all available at MidwayUSA now:
https://www.midwayusa.com/primers/br?cid=17587&targetLocation=%2F_%2FN-17587%3FNp%3D2%26Nr%3DAND%2528p_visible%253A1%252Ccustomertypeid%253A1%2529%26Nrpp%3D96%26Ns%3Dp_metric_sales_velocity%257C1%26Ntpc%3D1%26Ntpr%3D1
For those that like Xtreme bullets, they are having a 10% off sale right now. I checked and they have losts of 9mm in stock ATM:
https://www.xtremebullets.com/9mm-s/9666.htm
I wet tumble my brass and would not change that part of my process. However, depending on how much lube you use, the wet tumbler doesn't' always do a great job of removing it. Therefore, I dry tumble my brass in corncob media (with a capful or 2 of Nu-Finish car polish) after sizing it for about...
Welcome to THR. You will find a lot of great information as well as tons of knowledge on this forum.
This thread was created for members to post information and links to components that are available for purchase. The moderators are removing any chatter in order to insure that this thread is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.