Recent content by scoot12

Thanks. I looked at the picture closely and noticed that the small cylinder between the guide head and the spring is missing in my gun. I decided to go ahead and order the part from Numrich. I think it should solve the problem. Thanks for all your help.

Thanks for the reply. A picture of the correct spring assembly from Numrich Arms website can be found here: https://www.gunpartscorp.com/Products/276950C.htm

Gentlemen, Sorry if I posted this on the wrong thread. I think it is likely that the wrong spring assembly is installed. I have an H & R 676 and the hammer engages the spring immediately, as it should. Also the spring is a lot stronger in that revolver. I took some pictures, but I haven't...

H & R Problem Gentlemen, Thanks for the response. The head of the spring rod does rest on the hammer. When I cock the hammer, the head slides down for a half inch before it starts compressing the spring. There is no hole in the bottom of the spring rod in order to keep the spring compressed...

Hello everyone. Recently purchased an H & R 999 Sportsman. I can pull back the hammer about 3/4 inch without it engaging the spring. I thought maybe it had a plastic head on the spring rod that was broken. Checked it out and the head is steel. Any ideas on why the hammer doesn't engage the...