Recent content by Seafarer12

I voted for the revolver. I am not a 1911 guy. Revolvers are stupid simple just point and keep pulling the trigger till it goes click.

I voted for the Glock, (I own a G23) but I would be hard pressed to pass on an M&P. They don't have the options like the Glock but they sure do shoot nice.

I have the Hogue rubber ones on my SP101 and I would be hard pressed to find a better grip for me.

I wouldnt call new revolvers junk. But my S&W 19-2 is a lot nicer than my S&W 617. The same as my old model BH is nicer than my SP101. But they all shoot well and function flawlessly

All petitions need to get 150 signatures to go public. I know it is spitting in the wind but I had to do something. I already contacted congressman and senators.

I posted a link to another petition I made earlier today if your already registered might as well sign mine too if you agree with it. I need to get to 150 before it goes public.

Hello, I know it won't do a whole lot of good but, I have created a petition in response to all the closed mindedness I have see on both side of the gun control craziness as of late. The gun nazi's think that an ar15 was the cause of Sandy Hook and the NRA blamed it on video games like they...

I agree, I have a few barrels for my Glock the factory barrel is the least accurate as any of them. But it is the one I keep in there for home protection.

Like it has been said it isn't worth the trouble. I would like to have an old 32-20, I always like the S&W's better than the Colts.

Thats one way to do it. I use 0000 steel wool and some gun oil to get light surface rust off guns.

I do agree putting an AR together isn't rocket science. That being said I didn't want to fool with putting the upper together, thats why I went with Del-Ton.

I built mine for about 500 minus all the mags I bought. Compared to 1k I would say you save a little. You might just wait till the market totally drops out and prices drop.

I have a mid length kit and built it on a doublestar lower. The kit is just fine. There is just a hell of a wait. I am sure it is speeding up now. As far as tools go you just need the spanner for the stock. Del-ton assembles and test fires the uppers for you. It is worth it in my book. They are...

Like RC Said you will need to open up the gas port to get more gas to cycle the action since it will have less time. I would just find out the size of the port with a sbr and open it up to that.

You can cut it down no problem but I imagine you will need to resize your gas port to make up for the lack of the 5 inches of barrel length.