Recent content by SLMPDcitycop

It might seem like a silly question, but it will make me feel safer if I knew the answer before I tried it. I have a 3", 3"chambered judge. The only 3" shells I can find are weak birdshot. I found some federal personal protection shells made for the Judge, but they are 2.5". Is it safe to...

I have a glock 19. When I was on the department they mandated it have the NY2 orange trigger in it. How the heck do I replace this one and what parts do I need to put the 3.5lb trigger in?

Here's my opinion... Anything can be sand blasted off, even dura coat. Experiment with everything and find something that you like. I personally sand blast the finish off and apply dura coat without baking. Has worked for me for years. Sand blasters aren't too pricey from harbor freight tools.

If you dura-coat, you don't always have to bake.

This is MY view as a LEO. You were in VIOLATION of the law, by having no front plate. To be perfectly honest, its an arrestable offense. Its up to the officer's discretion if he chooses to arrest you, cite you, detain you for further investigation etc.. The first words out of you mouth being...

I ordered the DIY duracoat basic kit in matte black. It came with a small airbrush, propellant and an extremely small hose. After I did my long gun, which infact looks fantastic, I started on my smaller pistols. The propellant froze, so I put it in warm water. Then the airbrush hose link came...

Disregard, I got it apart.

I've come across a lil .25 pocket gun, which I'm going to duracoat. Does anyone know how to dis-assemble this gun?

Finally got it back! Well, finally got it back from Kimber, yesterday. The repair paperwork did not say much except "We recommend you use an oil based lube with Teflon, not the High Speed Gun Grease you had on the gun." They replaced the sear, and grip safety and thumb safety. Funny thing...

No, No and No.

I hated my CETME. I had to get rid of it. When I attempted a scope mount, I went with a claw mount. The claw mount was so tight that it prevented the reciever from cycling. Thus, scoping was out of the question. Go with the FN.

Where did you find it? I've been looking at the local stores and no luck.

The funny thing is I have had the gun for six month. It sat in my safe until two weeks ago. I shot it once, it shot fine. Stripped it, cleaned it and reassembled it. Then the problems started. The gun would fire with the safety on! Then it would do the decock thing. The dealer who is also a...

I've thrown around the same idea. Looking at my p22 mags, there is a considerable amount of room left in the mag after its completely loaded.

I sent it back to kimber today.