I have a gemtech GM9 suppressor that is rated for 9MM and 300 BLK subsonic. I recently bought a bolt action rifle in 308 win that has a threaded barrel. If the suppressor is rated for subsonic 300 BLK shouldn't it be rated for .308 win subsonic as well since it is the same bullet moving at the...
Thanks for the info Edward, I'll decap some today! I'm not after velocity, just hunting-adequate ammo under 250yards- I am looking for a hog/small deer round for my 6x45.
I am testing some 90gr 6x45 loads. I am within Accurate 2230 range but I get a little nervous seating to 2.26" for the magazine. Anyone see anything alarming about these? I see some SLIGHT ejector swipes.
Thanks for the help!
No, just through my .38 S&W 642. I'm wondering if the primer ignition popped the bullet out and the powder blew behind it. I'm at a loss. I didn't put much crimp on these loads.
I'm Wondering if I had one jump, then I fired the round with the bullet barely seated. There was powder on the outside of the case and I felt a good bit of powder burning on my hands. The bullet made it about an inch down the barrel
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.