JShirley-Thanks for clearing that up.:) . I personally like knives and would rather have one along,if I can't have a handgun,but understand the issue of carrying something you might never need. I still suggest a Victorinox Swisstool and an Endura.
I went whole hog into the matter. Bought a Dillon 650 I load all my .38,.45 and .223 on it. I find it works better than anything else I've tried. YMMV.
I did mine by getting a set of factory Speed-six grips,fit them onto the sec six and traced the outline onto the frame. I removed very little with a hacksaw and ground it close with a bench grinder,then dressed up with a file and sandpaper. The trick is to not remove too much. Remember that the...
Where I have to go shooting (county range) I never go alone. I always have a 'witness' due to past problems with range nazis. Sad to say the majority of leo's I run into have a bully mentality and operate as if they were above the law. I only remember one leo I met in the last ten years that...
Handguns:
Ruger MKII 5 1/2 bull ss
Ruger GP100 6" barrel ss
Ruger SP101 2 1/4 barrel dao
Rifles:
Marlin 39A
AR-15 Probably DPMS dissipator
Shotgun:
Mossberg 500AT w/ extra sporting barrel
I'm not a big rifle or shotgun kinda guy,think I'd rather add on a couple more handguns.
I have a Benchmade CSK in D2 and I'm quite pleased with it. Kershaw also makes the Outcast a big chopper in D2. Spyderco Makes a Military model in D2 as well.
TWBryan
Elm Creek Remember we gotta be PC,can't frighten the sheeple with that deadly spear. Besides the multiple tines give you a better chance of snagging that razor-toed bugger.
In another forum I suggested a giant size glue trap worn like a backpack,with quick release straps .When the...
Since the cat's gonna attack from behind the best thing would be to wear a big pack that covers up your back and head. For the ultra-light enthusiasts they could strap on an aluminum grate. If it didn't save 'em that cat could at least grill them. Of course you could just use a pitch fork as a...
Don't have numbers drills,going to have to try to assemble my small lathe. Easy to run off a few until I get the right diameter. Appreciate the thought.:)
TWBryan
Trying to fix a Winchester 250 lever-action .22 rifle. At some time in the past someone replaced the pin that holds the trigger assembly into the receiver with a piece of fiberglass rod. I'd like to replace it ,but need the dimensions. I suspect the rod being a single diameter is binding the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.