I recently purchased a 77/357 and had it threaded for a suppressor. I've been feeding it full power loads since I got it, but I'd also like to shoot some subsonics through it. That said, I don't have any powders that are ideal for 38 special loads, but I do have ~7lbs of WST that I keep on hand...
Hey Guys,
I've just completed building a new Savage/Shilen .260 Remington build, and I'm looking to top it with some new optics. It will primarily be a bench gun spending time at 100-700 yards, but may see 1-2 white tail trips a year.
I'm looking for something in the 6-20ish power range...
Hey guys,
I just got back from the range after putting 400 rounds down it. The Glock shot very well, and the lightened/smoothed trigger made all the difference with my groups. I did have a few instances of FTE, and the slide not holding open on the last round. I suspect thats just because the...
I'm taking it back out this morning. We'll see what happens. I'll use mags loaded with just two rounds to avoid anything stupid. If after 100 rounds I'm not having any problems, I'll start loading them up.
Thanks guys!
Good thought Gloob. I'm not sure. I thought I was generous on the polishing of that point. I think I'll pick up one of those Glockworx alum triggers w/ attached trigger bars. It's something I've wanted to do, and it would make me feel better about it. At least at this point it's down to a...
GlOOB,
Thanks for the response. I was sure to replace the pin that goes into the rear grip so I think I'm good there. I also don't think it's the disconnecter because I've replaced it with the ghost connector and had the exact same thing happen. I've also ensured that it's bent the appropriate...
Hey guys,
I just picked up my first Glock this past week at Cabelas. It's a Glock 17 RTF2. I've been a bench rest/target rifle shooter and reloader for a long time, but wanted to pickup a Glock before we eventually can't own these kind of things anymore.
Being that I'm used to triggers in...
The ring is not caused by case stretch. This is just a mark caused by the one-shot lube. It's basically where the case was run up into the die and the spot where the die stopped. It also doesn't help that the flash hit the case and overexposed it a bit.
This is not lake city brass. This is one...
Gentlemen,
I've had a weird problem as of late concerning flitz brass polish and Walnut media. I also use Hornady One-Shot spray. I've noticed that when resizing cases I get a walnut "crust" that comes out from the mouth of the case on the down stroke. This eventually builds up inside the...
Remington has been sold to Cerberus Capital Management
News from Reuters today:
http://www.reuters.com/article/bondsNews/idUSWEN615420070405
What do yall think?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.