I'm with the previous posters in that I do not correct others unless it is a potential safety issue, or if they ask for clarification on a particular term or issue.
My inlaws use 'clip' when they are really talking about a magazine...
I use the correct term when discussing guns/magazines...
I was wondering if the Hornady lnl classic single stage press would make a good companion for my LNL AP? I’m thinking a single stage for those miscellaneous tasks where a single stage press may be more appropriate than a progressive press – working up low quantity loads, decaping, sizing rifle...
Good point. Sometimes it feels like we spend more time worrying about how we look and running each other down than we do standing together and fighting for the 2A.
Bob,
Thanks for the update, sometimes things just don't work out. And thanks for facilitating this deal every year, it certainly is one of the highlights of my year. Lots of shooting, good food, and most importantly, great people.
Wayne
In my opinion, yes, the quality has gone Way downhill.
My wife was kind enough to buy me a new manufactured 39a as a gift a year or two ago. As you all know this is an expensive rifle at $550. She bought the rifle from one of the local gun shops.
While I obviously greatly appreciate such a...
Thanks for the replies. I think I'll try the RCBS dies to change it up a little from the Hornady's.
This set?
http://www.natchezss.com/product.cfm?contentID=productDetail&prodID=RC20415
What dies should I get to reload .380 in an LNL? I use Hornady die sets for .45, .38/.357, 9mm, .223 but was wondering if there is a particular die set that is more suitable for the .380?
Also, can folks recommend a bullet to use? I'm on the road right now and won't be near my reloading books...
Nematocyst,
Did you ever get your 39 straightened out? I seem to recall you had a smith do some work on it and you were going to have the barrel cut down?
Did the smiths work help your situation at all and if so how long did it take for them to do the work.
Thanks
And thanks for your...
Thanks for the replies, it sounds like there are several options I can look into.
I am a bit concerned about the current tops ability to take any sort of adhesive due to the many years of oil/grease/solvent soaking it has absorbed. I do have a sheet of 1/2 osb I could screw down on the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.