Recent content by wild willy

This right here just handle them with gloves afterwards.

350 Maine Guide

You can get a used professional tripod for a lot less than that.

Are you looking at new or old there’s an alert/recall on some of the first ones. S&W sends a little gauge to check the bolt mines a old one but was ok.Supposedly very few would fire when the bolt closed.

I have an adapter plate for my 600 to go from 3” to 2.5”.I usually buy 3” hulls or shells when the crimp gets bad I shorten them and load 2.5

Like was said before be very careful buying used.There are a lot of muzzeloaders out there with bad bores.If they greased the inside of the barrel be extra careful it’s a way to cover pitting

Is this the measure you painted?

Thanks You answered my question without me asking.I bought a set of no name grips that were too thick have to get the Hogues

There would be a lot of disappointed/enlightened hunters if they weighted every deer they got. There are hunters who have never weighed a deer and have no idea.

I have a 4x scope on mine I mostly shoot steel plates and hunt groundhog with it.But I have several times loaded the magazine full and with a front rest have no problem keeping them all in 3” shoot n see target at 100 yards not shooting as fast as I can but not fooling around,My 44 mag. Won’t...

My Hornady,RCBS,and Redding are not painted where they contact powder

I have the Marsupial gear works fine. It’s not as big and bulky as some. I have the standard model they didn’t have the enclosed model when I bought mine but I’ve had no problems in bad weather. The magnetic latch works great

Good luck with painting anywhere powder lays.It probably was just overspray.There’s a reason the inside of powder measures aren’t painted

Make sure you read the counterfeit warning in post #2.

6.8 SPC,6.5 Grendel or 7.62x39 would interest me more than 300 BO