Justin,
I found that the owner had taken this pistol down and had assembled the firing pin and springs out of order.
I got it torn down and after the firing pin was removed, I could then move the safety switch.
Many thanks to hexidismal..The instructions are excellent!
Hello,
I have taken a Beretta U-22 pistol in because the safety is stuck in the on/down position.
Does anyone have some insights on this? Or maybe the dissassembly info??
Thanks!
Bill P
I've run into this numerous times. I put the frame in a padded vise and with Optivisors, I saw the rear sight in two...being very careful to run the blade horizontally so as not to cut the frame.
Try the heat but I dont' like heat on a frame.
I have one bud that hunts deer standing/sitting/yapping/eating/smoking on field edges.
He *insists* on building a fire (this is during PA season -usually on snow) all the time cracking limbs with his rifle standing up against a tree and the guy always gets a buck! LOL
He maintains that the...
NYS DEC sets out decoy deer at times and they snag a pile of "hunters" shooting out the window.
My bud and I were driving along during deer season and stopped when we saw a huge buck standing motionless about 100 yds off in some low brush so we pulled over.
We stared at ol Bullwinkle for...
LOL @ me too!
I saw that and thought that it didn't look quite right..
For some reason I drew a blank on the "Magnum Research" name..I know better..
We only see maybe one of those every 2-3 years.
Hello, I have taken in a Dessert Eagle 357 mag and I need to get the firing pin spring and the firing pin retainer plate.
Sheesh! I got ahead of myself..This is listed under Magnum Research..Gun Parts has the plate after all..
(willp got redface now)...LOL
Thanks!
Bill P
You will need to buy a left handed safty button. You can't just turn the RH one around.
This requires dissassembling the trigger housing and removing the hammer and it's spring. This isn't too bad but it can be trickey getting it back together.
Synthetic stocks are ok until it comes time to shorten one. Most that I've seen have the butt plate or recoil pad recessed and fit to the inner periphery of the stock.
Also there are only 2 screw holes that are molded into the stock.
I have taken 1/2" off them and refit the pad..Thing is the...
Hello,
I have taken in a 12 ga dbl that is full & modified, non-chrome lined.
The owner wants mod & impoved cylinder. Where can I rent a reamer to go from full to Imp. Cyl ?
Thanks, Bill P
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.