Eggleston data

http://www.thehighroad.org/showthread.php?t=799115&highlight=eggleston

I had to seat that short in my cz.

I doubt you will find any manual data that short they did not test a similar fat bullet. I do not know the Egglston What gun are you shooting. I have to load MBC small ball LRN bullets very short in my CZ also. Just go with the start load given. You can use FMJ data for lead bullets again be sure to use the start load, you may gain some velocity.

I do not use HS 6 but do use Power Pistol and Longshot, Unique, HP 38 etc.

MBC says this:

http://missouribullet.com/details.php?prodId=51&category=5&secondary=8&keywords=

SmallBall!

#356125M
.356 Diameter
9mm Parabellum
124 Grain 9MM RN
Brinell 18
For General Shooting
NOTE: Seat to approximately 1.08"
Price per box of 500

Here you go.


http://www.egglestonmunitions.com/load-data.html

Gotcha, I can load some up in the morning and shoot them through a chrono if you would like using a cz75. I am down to only 18 so i could do a couple 5 shot strings.

ericuda said:

Here you go.


http://www.egglestonmunitions.com/load-data.html

Click to expand...

Well there ya go, Direct from the bullet maker. Can't beat that

Here are some results i did this morning. Nice 60 degrees with light wind. cz75, 4.6" barrel.

hs-6, 6.1 grains. starline, cci sp mag primers, oal 1.048
1191, 1196, 1224, 1205, 1172. avg 1197, es 52, sd 19

hs-6, 6.5 grains. starline, cci sp mag, oal 1.048
1244, 1278, 1241, 1222, 1253. avg 1247, es 56, sd 20

Shot good with clean cases. Didn't try too much for accuracy but for what i shot would be a nice mid to higher power load. If i was loading more i would make sure that this is not a compressed load. Looks very close. I have other powders i use for 9 but if i had more of this powder it makes a good load.