Vg6 Gamma tightens upside down
- Thread starter Glock702
- Start date
- Status
It's a crush washer....I use a couple gammas.
Let me look through my muzzle break mounting crap when I get home. I may have some 1/2" shims.
If your feeling energetic, what you can do is sand (using a flat surface and even pressure) the wide side of the crush washer down till your within 1/8turn or so of true and then clamp up your barrel and tighten it the rest of the way down.
Let me look through my muzzle break mounting crap when I get home. I may have some 1/2" shims.
If your feeling energetic, what you can do is sand (using a flat surface and even pressure) the wide side of the crush washer down till your within 1/8turn or so of true and then clamp up your barrel and tighten it the rest of the way down.
Last edited:
OP
OP
Glock702
Member
- Joined
- Oct 1, 2018
- Messages
- 44
crush washer, No i have not tightened it yet, but i'm sure it's not going to work. I may have to sand as Loonwulf suggested.
OP
OP
Glock702
Member
- Joined
- Oct 1, 2018
- Messages
- 44
could I add more crush washers, instead of sanding?
also someone suggested peel washers, instead of crush washers.
Ive never used peel washers, so cant realy comment on those.
I normal use a shim kit.
I wouldnt stack crush washers since that adds quite a bit of length, and more chances for misalignment, but again ive also never tried it.
That works as well, but make sure your clamping barrel well. Personally i dont realy like crushing, a crush washer that much, but its supposed to be fine.
OP
OP
Glock702
Member
- Joined
- Oct 1, 2018
- Messages
- 44
thanks for the reply, it was fairly easy, Got it timed to the correct postition with a crescent wrench and had my dad hold the receiver.
- Status
Similar threads
