• You are using the old High Contrast theme. We have installed a new dark theme for you, called UI.X. This will work better with the new upgrade of our software. You can select it at the bottom of any page.

New toy available from LEE

Status
Not open for further replies.
thanks RC ordered the gadget from midway and a lee sizing die. . almost as cheap to just order the three die set.
 
ran about 50 reloads thru my new Lee Factory taper crimp die. Could feel all of them getting somoothed out. Then tested all on a Wilson case gauge for headspace. Had two that would not seat fully. I plan on saving those and will remove powder primer etc and test on the new lee gadget when it comes in . Golly bum . if it works as i hope, will do all my cases. so would be sized and the bulge taken out. Or so i hoope . Will find out .

Thanks for the assistance.
 
I've heard that is a good tool, just remember, the brass might be weaker because of the original bulge and will probably have a shorter reloading life span...
 
i ran over 500 resized and deprimed tumbled 380 auto brass through the lee bulge buster. Most can push with finger. rest need a bump from the primer arm to push.

Amazed how many need a bump. sure will have fewer failure to fire or feed.
 
Status
Not open for further replies.
Back
Top