Did a Glock chop

improperlyaged · May 14, 2015

I got this pistol on a trade and the frame had already been heavily stippled. So I figured what the heck I may as well ruin it further. So here is the final version. I still have a little bit of cleaning to do to make it even and get rid of the little danglers that are hanging off. If I were to get a redo, I would have done all the cutting with a hacksaw as I could have been more precise than with a dremel.

GLOOB · May 14, 2015

If I were to get a redo, I would have done all the cutting with a hacksaw as I could have been more precise than with a dremel.

Look fine to me. Or is that the good side?

Kudos. I wish I could get a "crappy" Glock to modify the heck out of. My own Tupperware is held in a little too high esteem. A little relief of the trigger guard is as much as I have dared to modify the irreplaceable frame.

just for fun · May 14, 2015

improperlyaged said:
I got this pistol on a trade and the frame had already been heavily stippled. So I figured what the heck I may as well ruin it further. So here is the final version. I still have a little bit of cleaning to do to make it even and get rid of the little danglers that are hanging off. If I were to get a redo, I would have done all the cutting with a hacksaw as I could have been more precise than with a dremel.

Got this third gen 32. Ground off finger groves and somewhat straighten the back strap. not into the stippling but I sure do like what you've done to shorten your grip. Would consider it if there was a you tube video.

moxie · May 14, 2015

Nice job!

improperlyaged · May 15, 2015

not into the stippling

I'm not into the stipling either. It was done by the previous owner and it scrapes my side when wearing it. I am going to have to get a nice sweat shield holster to keep it off me.

bannockburn · May 15, 2015

improperlyaged

Good job! Looks like you made the best of an already modified situation. Have sometimes thought of doing something like that (shortening, not the stipling), to my G17 but didn't want to take a chance that I might not like the final shape or dimensions of the shortened frame.

deputy tom · May 15, 2015

OP it looks good to me. Dehorn the edges and stippling with fine sandpaper and you'll be good to go. tom.

entropy · May 19, 2015

Good job. Clean 'er up and you're GTG.

Did a Glock chop

improperlyaged

Member

GLOOB

Member

just for fun

Member

moxie

Member

improperlyaged

Member

bannockburn

Member

deputy tom

Member

entropy

Member

Similar threads