Everglades 124 HP works in all of mine
ever try this with dawn soap?
is Lee the cheapest? just want to use it to re-size rifle brass, the biggest is 30.06
stated to load some 9mm and found that all i had was magnum primers, is it safe?
I'll go with a 22 conversion kit, that makes sense
I don't have a can, but was just wondering if it could be done and cycle a AR.
the 300bo folks use them, just wondering if any one had tried them?
just wondering how small a amount of powder (335) can you load and still cycle a AR with a 62gr bullet? i know it wont be sub sonic.
I bolt my Lee presses on 2x6 and use a couple of C clamps to hold it on my work bench, use a 4' rod from a chimney sweep to push a shotgun brush...
i load everything with, but i resize on a O press
glue stick tubes will work in a .45, stick in and cut off, but will make a mess in the bore.
at 25 yds a 155gr drop 5" and the 208gr drop 3" both using 10.3gr of 2400, why do the 155 drop more then the 208? This is 762 round.
can a .311 bullet be used?
the only problem i have with mine is the large primers pop out of the primer arm about 1 in every 5, can't figure out why, cleaned the primer arm,...
i have loaded .308 bullets for my .310 bore AR in 762x39 and have good luck with them
didn't know i had it, bought it least 15 years ago and it was hidden in the garage, the garage is really a storage space that eats to many of my...
bought some 303 ammo, is HXP 75 corrosive?
for my different hand loads
its a AR pistol, 7 1/5' barrel, i will see how they look in a barrel, but i used a hornady gauge when setting up the dies.
Separate names with a comma.