I neither hate or dislike the 92. I carried one as an issued weapon on ocassion in the Air Force. My only problem with it was it was too big for my grip. I did fine in SA mode but DA was another matter.
Mine only change with the environment. Semi-autos for daily CCW. Roaming in the woods I carry revolvers primarily for the ability to load the first two chambers with shot loads for snake repellent.
My brother has a 788 .30/30 that he has used to kill a huge amount of whitetail over the past 50 years. About 20 years ago he expressed concern about it wearing out. By mere chance I saw one listed for sale in our state newspaper about a week later. It was his the next day. He now has two...
If you think that WLP's clothing purchases were the only area of malfeasance then you are being as willfully blind to his theft as the board of directors was. By his own admission he spent millions of dollars on himself, family and friends for private flights, gifts and other expenses. It was...
I've had my SA-35 for two months, it's serial # is in the 23,XXX range. First range trip ran 150 rounds through it and experienced two failure to extracts in the last twenty rounds. Not wanting to ship it back to SA I had a local smith install a Cylinder & Slide extractor. Since then I've...
I reload and cast for all the metallic cartridges I currently shoot. Absent reloading I would narrow the field:
Handgun - .22 LR, .38/357, 9mm
Rifle: .22LR, .357, .308
Shotgun: 12 gauge
Coming to this thread late. I've successfully used winchester primers for three decades. Only this past year I've experienced dud primers at the rate of 3-4%. These were all SPP red compound purchased prior to the covid era and stored in my climate controlled safe room. Initially I thought...
That is not a concern for me at all. My duty weapon was exposed to every enviroinment immaginable for 8-16 hour shift in and out of hot, cold, rain, ice etc. Wipe it down, clean as needed. After many years it just showed normal handling wear.
Here's another vote for the S&W M&P 22 compact. I've had mine for almost three years and it's chewed through a mixed bag of ammo without a single failure. My only criticism is that the trigger was gritty when new but has smoothed up with use.
W231/HP38 are my favorite powders for .38 Special 158 LSWC loads. I've used them since the 90's. 3.5 - 4.2 grains for a pleasant target load. For +p loads my go to for the same bullet is 6.0 grains of Power Pistol. Out of my 4" model 15 it chronographs at (+/-) 1050 FPS. This load is from...
I've had two 3" J frames (Ladysmith .38, and 60 Pro .357) and a 3" SP101. The Ruger had slightly less felt recoil but the actions on the S&W's enabled better accuracy for me. I no longer have any of the three but I'm strongly leaning towards getting another 60-15 in the standard configuration...
After much internal debate I went from the Shield to the Shield + early last year. Better fit to my hand and insignificant effect on concealment. At +/- 1,000 rounds through it, its been 100% reliable. Glad I made the change the Shield + is my primary CCW.
On my range trips I alternate between revolvers and semi-autos. Though semis are my preference for defensive carry, I enjoy shooting my revolvers more.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.