Also always a good idea to design things so they have a front and back. Where, because of the centerline spacing off the fasteners, they cannot be put on backwards.
You could turn money into noise with them.
If you buy a 300 blk, you could make even less noise with them...probably what they were intended for.
If they are not gas checked, you are probably pushing them too hard in a 30-06.
Whats your load data?
What is the diameter?
That looks like a job for the right sized set collar to me.
Clamp it on the part you don't want malled then proceed to mess up it's OD, instead of your gun part.
This is a 650, 5 station press.
Station 1. case feed, size/deprime
Station 2. prime, powder charge/flare.
Station 3. power check
Station 4 bullet feed and seat to depth.
Station 5 crimp.
https://www.youtube.com/watch?v=T3hVi6PuduM
It was. I never picked up a SPP 45 ACP brass case before 2001 or 2002. The only SPP 45 acp I know of before that was non reloadable aluminum cases, made it a non issue for them.
I don't carry revolvers much because I can often have more ammunition, in a lighter, more compact semi.
Back in the '80's Charter Arms and Federal came up with the "new", 9mm Federal round, a rimmed 9mm. Turns out it was so close to the 38 S&W, the backwards compatibility with weak revolvers...
No one looking for high speed would use those HKS speed loaders. SL comp II or III is a better choice but you won't keep up or beat Jerry with them.
With the moon clip guns you open the cylinder, dump the empty moon clip and "throw" the fresh one in. If you try and "put" them in, things begin...
Dry fire is a worthwhile activity. If you want to clear 8" plates at 25 yards dry fire at small targets. Instead of say a light switch cover, being your "target", use one of the screws that holds it in place.
Aim small/shoot small.
Now you have me wondering about using a torx bit to remove blades (leatherman) while flying and putting them back once I get there?
Would think every one at TSA would still "see pocket knife".
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.